Where to download firmware like 3.2 RC1, 3.2.RC12, so on?
@rfine7666 wrote: Thanks for help in advance I have been running APM 2.6 and 2.8 boards for a couple years and mostly always used firmware ver 3.2.1, or 3.1.5. I am always reading about ver 3.2 RC12...
View ArticleWhat is exactly VISION_POSITION_DELTA
@HumamHelfawiOptecks wrote: Hi, Since version 3.5-rc5 03-May-2017, VISION_POSITION_DELTA has been supported. I have several questions about it please: I should send this message at each new frame...
View ArticleClik here to view.
SITL on Linux Map "Unavailable"
@mehmetyldz87 wrote: Hi I encountered such a problem with map “Unavailable” . How can I solve this problem? 36477751-6296cb9a-1713-11e8-90f0-ed58bbb4a718.png788x527 17 KB Regards Mehmet Posts: 1...
View ArticleClik here to view.
Mavlink messages not received: LOCAL_POSITION_NED and POSITION_TARGET_LOCAL_NED
@R_Hodges wrote: Hello all! This is my first post here and I’m really hoping someone can help me out. We are developing some guidance routines on an external Linux computer that feeds commands to the...
View ArticlePixRacer Build Throttle Response Too High
@thatsnailguy wrote: Hey guys, Ive built a small PixRacer build and it takes off like a rocket with the smallest amount of throttle I give it. The only way I have been able to gain control of the...
View ArticleClik here to view.
Loiter mode pitch drift
@S259420 wrote: Hello! While testing Marvelmind for Indoor GPS, I’ve found a problem with loiter mode. I started from Stabilize Mode and all seems good. When I changed to Loiter Mode, the Desired...
View ArticleSingle Copter - (almost) Maiden Flight
@jaco wrote: We are new to single rotor airframes. Recently we flew our first custom designed single copter. The airframe was 3d printed. Link to picture:...
View ArticleIs there a way to read dataflash log from Skyviper?
@Huibean wrote: Since there is no sd card storage in skyviper fc board, it suppose can not save dataflash log as file, and mavlink way always bad logging in ground station, is there other way to read...
View ArticleClik here to view.
Sudden roll-pitch from wind gust or something else?
@rob215x wrote: I’ve been testing and tuning a new quad. I was testing it in windy conditions the other day, a 15-20mph wind with 25mph gusts. I wanted to see how it would handle the wind. It was in...
View ArticleQuadcopter tilts at take-off
@mppt wrote: Hello, I have built a drone with these characteristics: Frame Tarox XS690 Pixhawk 2.1 Cube with Arducopter 3.5 4 x ESC T-Motor Air 40A 4 x Motor T-Motor MN4012 KV480 4 x Propeller T-Motor...
View ArticleUnderstanding EKFs for Altitude
@crazy1pilot wrote: I am trying to better understand how the EKFs work and integrate within each other/ the parameters that control their POS estimations. I am configuring a multirotor for indoor...
View ArticleClik here to view.
V2450gps , won't fly higher than 10inch off the ground. New motors fitted
@Leztec wrote: I’m a newbie and this is my first drone. So I’ve had my sv for about a month and the rear left motor packed up. Had some heavy use and a couple of bumps, ok alot of bumps and a tangle...
View ArticleWhat is Toy Mode?
@lordneeko wrote: Has anyone tried turning “Toy Mode” off on this drone through the parameters? What exactly does Toy mode do? Certainly it makes flying easier, but what would be the difference in...
View ArticleAutotune crash log
@edge540T wrote: Well, it just fell down 9 meters suddenly in autotune, log auto analysis is a mess but I’m curious and can’t see anything by myself on logs. Uploaded precrash flight and postcrash arm...
View ArticleUAVCAN CANbus UC4H Group Buy of ESC nodes and STorM32NT/TSTorM controller boards
@mike wrote: This is a rare opportunity to get the newest STorM32NT/TSTorM controller brds and OlliW’s new ESC node with carrier for Kiss 32 ESC’s. Most people are aware of OlliW’s Gimbal controller...
View ArticleClik here to view.
My Quadrotor, it crashed
@winstonsaz wrote: Firmware: Arducopter 3.5.5 Frame: MiniQuad 210mm. X AutoPilot: 3DR Pixhawk Mini (purchased from Amazon) GPS: 3DR module uBlox M8N receiver ESC: EMAX D-SHOT Bullet Series 30A ESC...
View ArticleHow to show current flight parameters in a script?
@Paulo_Barros wrote: Hi, Everybody Can someone help me? I have a script in Python and I have the question: How to import the flight parameters from Mission Planner (latitude, longitude, altitude)...
View ArticleGets binding error calibrating Compass
@MickeM wrote: I know… old firmware. Its an old DJI F550 with an APM 2.5 with external uBlox 6 GPS/Compass. Internal Compass is disabled (cut on the board). It all works fine with the latest firmware...
View ArticleUsing "measured" MOT_THST_EXPO: What improvement can one expect?
@olliw42 wrote: Hey let’s assume one has measured the motor thrust curve and thus can determine a more accurate value for MOT_THST_EXPO, than the default of 0.65. Theoretically this should improve...
View ArticleAPM 2.8 STATUS LEDs
@Fahadjavaid wrote: Hi, Anyone please help me, my apm2.8 was working all well, I planned to make final touchups to the physical condition of the copter. When I finished cleaning all the quad,...
View Article