@rfine7666 wrote:
Thanks in advance for any Help, I received a lot of help from forum members when setting up my APM 2.6 Heli, now I am trying with a Pixhawk heli.
Pixhawk, 450 Hobbyking heli, Tarot FBL head, Emax digital servos, Flysky TH-9X radio and receiver (all this equipment was working well with APM)
I have install Chris Olson ArduHeli 3.5.4 V3 firmware, I am using PPM encoder, I have wired PPM encoder and Flysky receiver in cross channel Futaba pattern (worked well with APM) ESC is on channel 8, all channels seem to be working correct.
Problem is motor will not run?
In Mission Planner failsafe screen i can arm Pixhawk and I can see the channel 8 output bar increasing if ESC 3 wire is not plugged into channel 8 outpuit, but as soon as I plug in ESC to ch 8 output bar does not move? When plugged into ch 8 ESC is always beeping? I have tried different ESC and motors no change?
I have attached parameter file, Thanks for any help
Pixhawk 5-21-18.param (13.5 KB)
Posts: 2
Participants: 2