@neo4700 wrote:
Hello everyone
I tried for several months to work my Pixhawk unsuccessfully
I can not arm the controller. When I press the switch, the red LED stops flashing and remains on, but the LED of Pixhawk still following blue or green flashing GPS reception there or not even Stabilize mode.I find it equally impossible to calibrate the ESC, all procedures that I could find on the web or tutorial on YouTube does not. After the second disconnecting the battery the process stops
At first I configured the Pixhawk with Qgroudcontrol, then with MissionPlanner, but whether with one or the other problems persist
On the missionPlanner firware insalled is 3.3.3, the latest ,. I tried with the previous firmware, without changing anything to my problem
Thinking it is the pixhawk was defective I bought a second but the problem is the same with this one
My setup:
Ppixhawk 2 purchased from hobbygaga
power distribution plate with 2 spout (12 and 5 volt) purchased from hobbygaga (http://www.hobbygaga.com/fr-5-en-1-carte-d-amortissement-carte-de-distribution-d-alimentation-5v-12v-bec-courant-voltage-c-p270432.htm) all connected to a 6s lipo battery Turnigy my 16000
Module latest GPS (with Glonass)
telemetry module 433 mhz
Radio control Devo f12e receiver with 12 channels devo
6 Engine Emax 340 KV allimentés in 6S
6 ESC Emax BLHeli 40 ampsCan anyone help me
thank you
Posts: 2
Participants: 2